Concrete Contractors in Slidell, LA

What concrete services are available in Slidell?

Residential and commercial concrete work in Slidell covers the full range of flatwork: driveway replacement and new construction, patio and pool-deck slabs, garage floors, shed pads, sidewalks, parking lot sections and commercial equipment pads. Decorative finishes including exposed aggregate, broom texture and stamped patterns are available on any residential pour. Commercial bids include reinforcement schedules and mix designs matched to load requirements.

What do Slidell's ground conditions mean for concrete work?

Slidell's sandy pine-flat soil is the reason slab edges and subgrade drainage require more attention here than slab thickness alone. Unlike the soft alluvial clay on the south shore, where slabs sink because saturated soil consolidates under load, Slidell's sandy subgrade stays firm under the slab itself. The problem is water moving laterally through that permeable soil during a heavy rain event. As water channels under the slab perimeter, fine particles migrate with it, leaving voids directly beneath the slab edge. Once the void forms, edge cracking and eventual section loss follow.

How is the subgrade prepared to prevent washout in Slidell?

Correct subgrade preparation on a Slidell pour starts with grading the excavated base to direct water away from the slab at a minimum 2 percent fall. A 4 to 6 inch layer of compacted crushed limestone or graded aggregate is placed and compacted in two lifts before forming, giving the slab a stable, interlocked base that resists particle migration. On slabs larger than 400 square feet, a 6-mil polyethylene vapor barrier is placed over the compacted base before the pour. Edge protection on exposed slab perimeters uses a thickened-edge detail, dropping from 4 inches at center to 6 inches at the perimeter beam, so the slab carries its own bearing at the point most exposed to runoff.

What reinforcement and mix specs apply to Slidell flatwork?

Residential driveways are poured at 4 inches of 3500 PSI concrete with number 3 rebar on 18-inch centers or welded wire reinforcement as an alternative. Commercial slabs and equipment pads are specified at a minimum of 4000 PSI with number 4 rebar on 12-inch centers. The water table sitting 5 to 12 feet below grade means the slab itself is not subject to hydrostatic pressure from below, so the reinforcement focus shifts to flexural capacity at slab edges rather than waterproof admixtures.

What does concrete work cost in Slidell?

Most residential concrete work in Slidell prices between $8 and $13 per square foot in 2026, with total project cost determined by four factors: slab area, subgrade condition, reinforcement spec and finish type.

Typical project ranges in Slidell for 2026:

• Driveway replacement (400 to 800 sq ft): $3,200 to $10,400
• Residential patio slab (200 to 500 sq ft): $1,600 to $6,500
• Garage floor or shed pad (up to 600 sq ft): $2,400 to $7,800
• Commercial flatwork: priced per project with a reinforcement and mix schedule

The number moves up when the existing subgrade requires regrading for drainage fall, when root removal adds excavation time, or when a stamped or exposed-aggregate finish is specified. The number moves down on straightforward new-construction pads where the subgrade is already graded by the builder.

What permits and approvals are required in St. Tammany Parish?

Permit requirements for concrete flatwork in St. Tammany Parish vary by project scope and site conditions, and the determining authority is the St. Tammany Parish Department of Permits. In general, projects that add new impervious surface, alter surface drainage patterns, involve work within a public right-of-way, or fall within a designated flood zone are the types most likely to require review before work begins. Replacing an existing slab of the same footprint may or may not require a permit depending on site-specific factors.

No fee amounts, setback figures or form numbers are stated here because those details are set by the parish and subject to change. Confirm the requirements for your specific parcel with the St. Tammany Parish Department of Permits before scheduling any work.

Recent concrete projects in Slidell

Driveway replacement, Slidell

640 square feet. The existing slab had lost bearing along the left edge where repeated storm runoff had washed material from beneath the perimeter. Removed the failed section to subgrade, regraded the base at a 3 percent cross-fall toward the lawn edge, compacted 6 inches of crushed limestone in two lifts and poured 4 inches of 3500 PSI concrete with a thickened-edge perimeter beam at 6 inches. Number 3 rebar on 18-inch centers throughout. Broom finish, control joints at 10-foot intervals. Three days from demolition to final broom.

Rear patio slab, Slidell

320 square feet. Sandy subgrade showed uneven surface where pine root mass had been cleared by the owner prior to our arrival, leaving a 4-inch depression across roughly one-third of the pour area. Filled the depression with compacted aggregate base, brought the full area to a consistent grade, placed 6-mil poly and poured 4 inches of 3500 PSI concrete. Exposed-aggregate finish with a salt-and-wash technique. Two days on site.

How do you get a concrete estimate in Slidell?

A free on-site estimate in Slidell takes 30 to 45 minutes. The visit covers measuring the area, reading the existing subgrade grade and drainage fall, noting any tree roots or prior damage, and confirming the finish and reinforcement spec. A written line-item price is delivered within 24 hours of the visit. Call or submit the contact form to schedule.